568 Results for For sale in Mcgregor Mn

• Mcgregor, MN
• Collectibles

This clock is pretty scarce. Haven’t seen too many of these around. There are no markings on the front of the clock. Since I have other snap-on clocks am assuming that it was around 2000 to 2002. The magnet is pre…

• Mcgregor, MN
• Collectibles

All 4 of these containers are in very good condition. The 85 count container measures 3.25 in. in height and is 1.25 in. in diameter. The 3 smaller 45 count containers measure 2.5 in. in height and is 1 in. in diameter.…

• Aitkin, MN
• Sporting Goods

This auction is for a vintage Wiseco brand snowmobile piston for a CCW 400/2, 3, 4 twin cylinder motor used in the John Deere snowmobiles. The part number on this is 2013 P2 and this is a .020 oversize piston. This …

• Aitkin, MN
• Sporting Goods

This listing is for a vintage Yamaha snowmobile suspension spring, right hand side, rear. This is a NOS part, the part number for this is 90508-70085 and this number replaces part number 806-47364. Looked these up o…

• Aitkin, MN
• Sporting Goods

This auction is for a vintage Arctic Cat snowmobile coat or jacket. This is a size large according to the tag, does not say if it's a childs or womens but it's pretty small so I'm guessing its a childs. This is in n…

• Aitkin, MN
• Sporting Goods

This listing is for an OEM vintage Ski Doo snowmobile motor head gasket. The part number on this gasket is 420850136. I tried looking the part number up online but could not come up with an application for this numb…

• Aitkin, MN
• Sporting Goods

This listing is for a Ski Doo clutch bushing. This is a new, OEM part, the part number on this is 414 6139 00. This measures 50.25mm outside, 38.1mm inside and 31.60 mm tall. I tried looking this up on line but coul…

• Aitkin, MN
• Sporting Goods

This listing is for a vintage snowmobile carb insulator block. This is a Tillotson HR or Walbro WR bolt pattern. This is a NOS carb block. This measures 8mm thick, 35mm bore, stud holes 9mm, overall length 76mm and …